HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 2 - LAN Switching Co - Page 160
GVRP forbidden registration mode configuration example, Network requirements, Configuration procedure
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 160 highlights
[DeviceB-GigabitEthernet1/0/1] port trunk permit vlan all # Enable GVRP on GigabitEthernet 1/0/1, and set the GVRP registration mode to fixed on the port. [DeviceB-GigabitEthernet1/0/1] gvrp [DeviceB-GigabitEthernet1/0/1] gvrp registration fixed [DeviceB-GigabitEthernet1/0/1] quit # Create VLAN 3 (a static VLAN). [DeviceB] vlan 3 [DeviceB-vlan3] quit 3. Verify the configuration: Use the display gvrp local-vlan command to display the local VLAN information that GVRP maintains on ports. For example: # Display the local VLAN information that GVRP maintains on port GigabitEthernet 1/0/1 of Device A. [DeviceA] display gvrp local-vlan interface gigabitethernet 1/0/1 Following VLANs exist in GVRP local database: 1(default), 2 According to the output, information about VLAN 1 and static VLAN information of VLAN 2 on the local device are registered through GVRP, but dynamic VLAN information of VLAN 3 on Device B is not. # Display the local VLAN information that GVRP maintains on port GigabitEthernet 1/0/1 of Device B. [DeviceB] display gvrp local-vlan interface gigabitethernet 1/0/1 Following VLANs exist in GVRP local database: 1(default), 3 According to the output, information about VLAN 1 and static VLAN information of VLAN 3 on the local device are registered through GVRP, but dynamic VLAN information of VLAN 2 on Device A is not. GVRP forbidden registration mode configuration example Network requirements As shown in Figure 48: • Device A and Device B are connected through their ports GigabitEthernet 1/0/1. • Enable GVRP and configure the forbidden registration mode on ports to prevent the registration and deregistration of all VLANs but VLAN 1 between the two devices. Figure 48 Network diagram Configuration procedure 1. Configure Device A: # Enable GVRP globally. system-view 151