HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 2 - LAN Switching Co - Page 52

Task Command Remarks Display summary information about all aggregation groups. display link-aggregation summary [ | { begin | exclude | include } regular-expression ] Available in any view Display detailed information about display link-aggregation verbose a specific or all aggregation [ bridge-aggregation [ interface-number ] ] [ | Available in any view groups. { begin | exclude | include } regular-expression ] Clear LACP statistics for a specific or all link aggregation member ports. reset lacp statistics [ interface interface-list ] Available in user view Clear statistics for a specific or all reset counters interface [ bridge-aggregation aggregate interfaces. [ interface-number ] ] Available in user view Ethernet link aggregation configuration examples In an aggregation group, only ports that have the same port attributes and class-two configurations (see "Configuration classes") as the reference port (see "Reference port") can operate as Selected ports. Make sure that all member ports have the same port attributes and class-two configurations as the reference port. The other settings only need to be configured on the aggregate interface, not on the member ports. Layer 2 static aggregation configuration example Network requirements As shown in Figure 9: • Device A and Device B are connected through their respective Layer 2 Ethernet interfaces GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3. • Configure a Layer 2 static aggregation group on both Device A and Device B. Enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20 at one end to communicate with VLAN 20 at the other end. • Enable traffic to be load-shared across aggregation group member ports based on the source and destination MAC addresses. Figure 9 Network diagram 43