Intel S2600CP Technical Product Specification - Page 160

Intel® Server System P4000CP Power System Options Intel® Server Board S2600CP and Server System P4000CP TPS 13.3.1.4 Temperature Requirements The power supply operates within all specified limits over the Top temperature range. All airflow passes through the power supply and not over the exterior surfaces of the power supply. Table 93. Environmental Requirements Item Top_sc_red Description Operating temperature range; spreadcore redundant ( 60% load, 3000m, spreadcore system flow impedance2 ) Min 0 Max 60 Units C Top_sc_nr Operating temperature range; spreadcore non-redundant (100% load, 3000m, spreadcore system flow impedance2 ) 0 50 C Top_rackped_ Operating temperature range; rack/pedestal 900m 900 ( 100% load, 900m, rack/pedestal system flow impedance2 ) 0 45 C Top_rackped_ Operating temperature range; rack/pedestal 3000m 3000 ( 100% load, 3000m, rack/pedestal system flow impedance2 ) 0 40 C Texit Maximum exit air temperature 68 C Tnon-op Non-operating temperature range. -40 70 C Altitude Maximum operating altitude 3 3050 m Notes: 1. 2. Under normal conditions, the exit air temperature shall be less than 65C. 68C is provided for absolute worst case conditions and is expected only to exist when the inlet ambient reaches 60C. Top_rackped_900 condition only requires max altitude of 900m. The power supply meets UL enclosure requirements for temperature rise limits. All sides of the power supply with exception to the air exhaust side are classified as "Handle, knobs, grips, and so on held for short periods of time only". 13.3.2 AC Input Requirements 13.3.2.1 Power Factor The power supply meets the power factor requirements stated in the Energy Star® Program Requirements for Computer Servers. These requirements are stated below. Table 94. Power Factor Requirements for Computer Servers Output power Power factor 10% load > 0.65 20% load > 0.80 50% load > 0.90 100% load > 0.95 Tested at 230Vac, 50Hz and 60Hz and 115VAC, 60Hz Tested according to Generalized Internal Power Supply Efficiency Testing Protocol Rev 6.4.3. This is posted at http://efficientpowersupplies.epri.com/methods.asp. 13.3.2.2 AC Inlet Connector The AC input connector is an IEC 320 C-14 power inlet. This inlet is rated for 10A/250VAC. 13.3.2.3 AC Input Voltage Specification The power supply operates within all specified limits over the following input voltage range. Harmonic distortion of up to 10% of the rated line voltage does not cause the power supply to go out of specified limits. Application of an input voltage below 85VAC does not cause damage to the power supply, including a blown fuse. 144 Revision 1.2 Intel order number G26942-003