Yamaha AW4416 Reference Guide - Page 174

Display message list Appendix Messages AUTOMIX DISABLED. AUTOMIX MEMORY FULL! AUTOMIX NOT RUNNING. AUTOMIX REC ABORTED. AUTOMIX RECORDING. AUTOMIX RUNNING. BANK A SELECTED BANK B SELECTED CANNOT ASSIGN DIGITAL-ST-IN. CANNOT CHANGE THE MUTE CANNOT PLAY THIS PAGE CANNOT RECALL AUTOMIX CANNOT REDO CANNOT SELECT (MTC SLAVE) CANNOT SELECT (WC EXTERNAL) CANNOT SET MARK CANNOT UNDO CANNOT USE BOTH SLOTS! CD PLAY MODE NOW. DIFFERENT TC FRAME TYPE DIGITAL-ST-IN REC PROHIBIT. DIGITAL-ST-IN SYNC ERROR! DIN TO STEREO BUS REFUSE. DISK BUSY EFF1 INSERT RELEASED EFF2 INSERT RELEASED FOR EFFECT2 ONLY. IN/OUT POINTS TOO CLOSE Automix is not enabled, and cannot be recorded. Automix memory has no free area. Automix has been stopped, so recording is not possible. Pause the recorder, and then playback. Automix recording was stopped, and the data was discarded. The operation cannot be executed since automix is being recorded. The operation cannot be executed since automix is being recorded or played. Since sampling pad bank A is selected, muting cannot be defeated for this pad. Since sampling pad bank B is selected, muting cannot be defeated for this pad. DIGITAL STEREO IN cannot be assigned to the stereo bus cascade. Muting cannot be defeated since this would exceed the number of simultaneously playable tracks. Playback is not possible in this page. Recall is not possible, since automix data has not been stored. Redo (re-execution of an operation) is not possible. Since the AW4416 is set to be the MTC slave, the external word clock cannot be selected as the word clock source. Since the external word clock is selected as the word clock source, the AW4416 cannot be set as the MTC slave. It is not possible to specify a mark at an already-specified position. Undo (cancellation of an operation) is not possible. OPTION I/O slot 1 and slot 2 cannot be used simultaneously. Since the AW4416 is in CD Play mode, this operation is not possible. MTC of a different frame type than the internal setting is being received. Recording is prohibited for the signal being input from DIGITAL STEREO IN. The signal being input from DIGITAL STEREO IN is not synchronized to the word clock master. Since the signal was interrupted, cascading from DIGITAL STEREO IN to the stereo bus has been defeated. The reading speed of the internal hard disk is not fast enough, or the reading speed has slowed down because the recorded data has become fragmented. Effect 1 has been released from insertion because a patch library was recalled. Effect 2 has been released from insertion because a patch library was recalled. The selected effect program can be used only with effect 2. The auto punch-in/out interval is too short. It cannot be set less than approximately 100 msec. 39 - Reference Guide Appendix-