Yamaha AW4416 Reference Guide - Page 33
Solo Setup
View all Yamaha AW4416 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
SET UP screen Solo Setup page Make solo settings [Function] Make various settings related to the Solo function. [Key operation] • [SETUP] key ¡ [F3] (Solo Setup) key (*1) • Repeatedly press the [SETUP] key until the screen shown at the right appears. *1. In the SET UP screen, the tabs dis- played at the bottom of the screen are divided into two groups. If the Solo Setup tab is not assigned to the [F3] 5 key when you press the [SETUP] key, press the [SHIFT] key + [F1] (CHANGE TAB) key to switch the tabs. [Mouse operation] M button ¡ SETU button ¡ Solo Setup tab 1 2 34 [Screen functions] A STATUS Turn on one of the following two buttons to select the operating mode of the Solo function. q RECORDING SOLO If this button is on, the solo signal will be output via the dedicated SOLO bus to the MONITOR OUT jacks/PHONES jack. (The output of the stereo bus and buses 1-8 will not be affected.) You can also monitor channels that are not assigned to the stereo bus or to buses 1-8, or channels whose [ON] key is off. q MIXDOWN SOLO If this button is on, the solo signal will be output via the stereo bus to the MONITOR OUT jacks/ PHONES jack. When the Solo function is turned on, only the channel(s) being soloed will be sent to the stereo bus, and the remaining channels will be muted. It is not possible to monitor channels that are not assigned to the stereo bus. B LISTEN When RECORDING SOLO is selected for 1, you can select one of the following two locations from which the signal will be sent from each channel to the SOLO bus. q PRE FADER The pre-fader signal will be sent to the SOLO bus. Since the pan setting of the channel will have no effect, the signal being monitored from the MONITOR OUT jacks/PHONES jack will be monaural. q AFTER FADER The signal after passing through fader and pan will be sent to the SOLO bus. The pan and fader settings of each channel will affect the signal that is monitored by the MONITOR OUT jacks/ PHONES jack. C SEL MODE (select mode) Select one of the following two ways by which the monitored signal will be selected when the Solo function is on. 26 - Reference Guide