Dell Latitude CPi User Guide - Page 146
System Flash Codes, Run the System Set test group in the Dell Diagnostics.
View all Dell Latitude CPi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
Non-system disk or disk error The diskette in drive A or your hard-disk drive does not have a bootable operating system installed on it. If you are trying to boot from the diskette, replace it with one that has a bootable operating system. Not a boot diskette There is no operating system on the Boot the computer with a diskette that contains an operating system. diskette. Optional ROM bad checksum The optional ROM apparently failed. Call Dell for technical assistance. (For instructions, see Getting Help.) Sector not found The operating system cannot locate Run the appropriate utility to check the file structure on the diskette or a sector on the diskette or hard- hard-disk drive. If a large number of sectors are defective, back up the disk drive. You probably have a bad data (if possible), and then reformat the diskette or hard-disk drive. sector or corrupted FAT on the diskette or hard-disk drive. Seek error The operating system cannot find a If the error is on the diskette drive, try another diskette in the drive. specific track on the diskette or hard-disk drive. Shutdown failure A chip on the system board may be Run the System Set test group in the Dell Diagnostics. (For malfunctioning. instructions, see Running the Dell Diagnostics.) Time-of-day clock lost power Data stored in NVRAM has become corrupted. Connect your computer to AC power to charge the battery. If the problem persists, try to restore the data. To restore the data, press to enter the System Setup program. Then immediately exit it (as described in Using the System Setup Program). If the message reappears, call Dell for technical assistance. (For instructions, see Getting Help.) Time-of-day clock stopped The reserve battery that supports the data stored in NVRAM may be read. Connect your computer to AC power to charge the battery. If the problem persists, call Dell for technical assistance. (For instructions, see Getting Help.) Time-of-day not setplease run the System Setup program The time or date stored in the System Setup program does not watch the system clock. Correct the settings for the Date and Time options. (For instructions, see Using the System Setup Program.) Timer chip counter 2 failed A chip on the system board may be Run the System Set test group in the Dell Diagnostics. (For malfunctioning. instructions, see Running the Dell Diagnostics.) Unexpected interrupt in protected mode The keyboard controller may be malfunctioning, or an installed memory module may be loose. Run the RAM test group and the Keyboard Controller Test in the Dell Diagnostics. (For instructions, see Running the Dell Diagnostics.) Warning: Battery is critically low. The battery is running out of charge. Replace the battery, or connect the computer to AC power. Otherwise, activate suspend-to-disk mode or turn off the computer. System Flash Codes When errors that occur during the boot routine cannot be reported on the built-in display or on an external monitor (if attached), the Num Lock, Caps Lock, and Scroll Lock indicators (see Figure 1) may flash together in a pattern of lights (or flash code) that identifies the problem. For example, one flash, followed by a second flash, and then a burst of three flashes (code 1-1-3) means that the computer was unable to read the data in nonvolatile random-access memory (NVRAM). This information is important to the Dell support staff if you need to call for technical assistance. The Num Lock, Caps Lock, and Scroll Lock indicators flash briefly when the computer is turned on. The flash codes, if needed, occur