Samsung CLX-8380ND User Manual (user Manual) (ver.5.00) (English) - Page 54
Sending a fax manually (On Hook Dial), Automatic resending, Redialing the last number
View all Samsung CLX-8380ND manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
the right side of the screen, if you have stored frequently used fax numbers. 6 To add a number, press Add No. 7 Press Start on the control panel. The machine starts to scan and send a fax to destinations. Note • When you want to cancel a fax job, press Stop before the machine start transmission. Or press the Job Status button, and select the job you want to delete, press Delete. • If you used the scanner glass, the machine shows the message asking to place another page. • While the machine is sending a fax, you can not send an email at the same time. (Page 7.4) Sending a fax manually (On Hook Dial) 1 Press Fax from the Main screen. 2 Place the originals face up into the DADF. 3 Adjust the document settings in the Image tab. 4 Select Duplex and Resolution options in the Basic tab. 5 Press On Hook Dial on the control panel. 6 Enter a fax number using the number keypad on the control panel. If the number is which you have dialed recently, press the Redial/ Pause button on the control panel to show ten recent fax numbers and select a fax number. 7 Press Start when you hear a high-pitched fax signal from the remote fax machine. Note Color faxes are only supported when faxes are sent manually. (Page 6.6) Automatic resending When the number you have dialed is busy or there is no answer, the machine automatically redials the number. To change the time interval between redials and/or the number of redial attempts, refer to the next following steps. 1 Press Machine Setup on the control panel. 2 Select Admin Setting. When the login message pops up, then enter password and press OK. (Page 3.5) 3 Press the Setup tab > Fax Setup. 4 Press Redial. 5 Select Redial Term and Redial Times. 6 Press OK. Redialing the last number 1 Press Fax from the Main screen. 2 Adjust the document settings in the Image tab. 3 Place the originals face up into the DADF. 4 Press the Redial/Pause button on the control panel to show ten recent fax numbers. 5 Select a fax number in the list and press OK. The machine automatically begins to send. Delaying a fax transmission You can set your machine to send a fax at a later time when you will not be present. 1 Press Fax from the Main screen. 2 Place the originals face up in the DADF. 3 Adjust the document settings in the Image tab and the Basic tab. 4 Press the Advanced tab > Delay Send. 6.3