HP Color LaserJet CM2320 Service Manual - Page 131
Required tools, Types of screws, CAUTION, WARNING
View all HP Color LaserJet CM2320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
Required tools ● Number 2 Phillips screwdriver with a magnetic tip and a 152-mm (6-inch) shaft length ● Precision slotted screwdriver with a 1 mm (0.04 in) blade width NOTE: This fine-point tool is required to release the front door pins. The width of the blade must be 2 mm (0.08 in) or less to be able to drive the door pins out of the mounting holes. ● Small, slotted screwdriver ● Needle-nose pliers ● Snap-ring pliers ● ESD mat (if one is available) ● Penlight (optional) CAUTION: Always use a Phillips screwdriver (callout 1). Do not use a pozidrive screwdriver (callout 2) or any motorized screwdriver. These can damage screws or screw threads. Figure 6-1 Phillips and pozidrive screwdriver comparison Types of screws WARNING! Make sure that components are replaced with the correct screw type. Using the incorrect screw (for example, substituting a long screw for the correct shorter screw) can cause damage to the product or interfere with product operation. Do not intermix screws that are removed with one component with the screws that are removed from another component. For a complete list of screw types and part numbers, see Parts and diagrams on page 327. ENWW Removal and replacement strategy 119