HP Color LaserJet CM2320 Service Manual - Page 140
Pickup roller (Tray 2 and Tray 3), Remove Tray 2.
View all HP Color LaserJet CM2320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Pickup roller (Tray 2 and Tray 3) The roller must be rotated into the service position to remove it. CAUTION: Avoid touching the spongy roller surface unless you are going to replace the roller. Skin oils on the roller can cause paper pickup problems. 1. Turn the product on, and wait for it to reach the Ready state. Perform the following steps to rotate the roller to the service position. NOTE: If you have removed Tray 2 to service the product, reinstall the tray before turning the power on. TIP: The following steps rotate the engine paper-pickup roller and the Tray 1 paper-pickup roller into the service position. a. Open the 2ndry Service menu by pressing the Left Arrow button and the Cancel button simultaneously. b. Use the arrow buttons to select Pick roller, and then press OK. Press OK again to confirm that you want the roller to rotate. c. Listen for the roller to rotate. When the roller is done rotating, unplug the power cord and then place the power switch in the off position. CAUTION: It is important to place the power switch in the off position after unplugging the power cord so that the product power does not come on immediately when the power cord is plugged in again. d. Remove Tray 2. e. Perform the remaining steps in this procedure to remove the roller. After replacing the roller, plug the power cord into the product, and then use the power switch to turn the power on. 128 Chapter 6 Removal and replacement ENWW