Kyocera KM-C3232E Fax System (N) Operation Guide Rev-1.2 - Page 40

Fax Operation (Basic Use) 2 Set the documents face-up on the document tray. NOTE: If the documents are set properly, the document set indicator will be lit green. DO NOT set more documents than indicated by the paper volume lines that are located on the inside of the rear document insert guide. Setting more than the acceptable number of documents can be the cause of document jams. Refer to the Operation Guide for your machine for more detailed information on the Document Processor. It is possible to set duplex (2-sided) documents and have both the front and back sides of those documents transmitted. (Refer to page 3-2.) Setting the Documents on the Platen Documents can also be transmitted by lifting open the Document Processor and setting one document at a time directly on the platen. Always use the platen when transmitting pages from books and the like. 1 Set the document face-down and align it properly with the lines on the original size scales. 2 When transmitting single-sheet documents directly from the platen, be sure to close the Document Processor. Caution: Do not leave the document processor open as there is a danger of personal injury. 4 Dialing a destination fax number Use the numeric keys to enter the destination fax number. NOTE: The destination fax number can be up to 32 digits in length. If a mistake is made at any point in entering the fax number, press the [] or [] cursor key to move the cursor to the desired position and enter the correct number as desired, or press the Stop/Clear key and enter the full number once again from the beginning. 2-4