Kyocera KM-C3232E Fax System (N) Operation Guide Rev-1.2 - Page 46

Fax Operation (Basic Use) Receiving Documents Automatically (Automatic Fax Reception) Automatic Fax Reception is the default setting for fax reception in this machine and no special settings are required for its use. The data for an incoming fax are stored and then printed out in a single batch at the end of the communication. NOTE: In order to use the Automatic Fax Reception mode, it is necessary to select the [Fax Reception] ([Fax Rx]) key under Selecting the Automatic Reception Mode (Receive Mode setting) on page 7-12. Reception modes This fax machine offers the following 4 or 5 (depending upon the region of use) ways to receive a fax. • Automatic Fax Reception....Refer to this page. • Manual Fax Reception.....Refer to page 3-25. • Auto FAX/TEL Switching.....Refer to page 5-2. • TAD Reception.....Refer to page 5-4. • D.R.D. Reception.....Refer to page 5-6. > Checking the reception mode Make sure that Auto RX is displayed. for fax transmission. riginal & assign destination. Abbrev. Application TX setting Register Print Report Memory usage: .0% OCT-11-2005 16:00 Dest. check Re-dial On-hook Memory TX Auto RX > Changing the reception mode 1 Press the reception mode select key when you want to change the reception mode. 2 Press the key that corresponds to the desired reception mode. Ready for fax transmission. Receive Mode Memory OCT-11 Auto RX Manual RX Answering Machine 1 Receiving a fax When a fax comes in, fax reception will begin automatically after the amount of time equal to a designated number of rings. NOTE: Once fax reception begins, the [Status] ([Act status]) key will appear in the bottom right of the touch panel. 2-10