D-Link DGS-3130 User Manual - Page 159

DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide Parameter Ignore Topology Change Description Select to enable or disable the Ignore Topology Change feature here. Click the Apply button to accept the changes made. MLD Snooping Groups Settings This window is used to display and configure the MLD snooping static group, and view MLD snooping group. To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD Snooping Groups Settings, as shown below: Figure 5-73 MLD Snooping Groups Settings Window The fields that can be configured in MLD Snooping Static Groups Settings are described below: Parameter VID Group Address Unit From Port - To Port VID Group Address Description Enter the VLAN ID of the multicast group here. The range is from 1 to 4094. Enter the IPv6 multicast group address here. Select the Switch unit that will be used for this configuration here. Select the appropriate port range used for the configuration here. Click the radio button and enter a VLAN ID of the multicast group. The range is from 1 to 4094. Click the radio button and enter an IP multicast group address. Click the Apply button to accept the changes made. Click the Delete button to remove the specified entry. Click the Find button to locate a specific entry based on the information entered. Click the Show All button to view all the entries. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. The fields that can be configured in MLD Snooping Groups Table are described below: 149