D-Link DGS-3130 User Manual - Page 363

DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide Parameter IPv6 Address Domain Name Initial TTL Max TTL Port Timeout Length Source IPv6 Address Probe Number Description Select and enter the IPv6 address of the destination here. Select and enter the domain name of the destination here. Enter the initial Time-To-Live (TTL) value here. The range is from 1 to 255. Enter the Time-To-Live (TTL) value of the trace route request here. This is the maximum number of routers that a trace route packet can pass. The trace route option will cross while seeking the network path between two devices. The range for the TTL is 1 to 255 hops. Enter the port number here. The value range is from 1 to 65535. Enter the timeout period while waiting for a response from the remote device here. A value of 1 to 65535 seconds can be specified. The default is 5 seconds. Enter the length value here. This specifies the number of bytes of the outgoing datagram. The range is from 1 to 1420 bytes. Enter the source IPv6 address here. The specified IPv6 address must one of the IPv6 addresses configured for the Switch. Enter the probe time number here. The range is from 1 to 1000. If unspecified, the default value is 1. Click the Start button to initiate the route trace for each individual section. After clicking the Start button in IPv4 Trace Route section, the following IPv4 Trace Route Result section will appear: Figure 13-16 Trace Route (Start) Window Click the Back button to stop the trace route and return to the IPv4 Trace Route section. Reset This window is used to reset the Switch's configuration to the factory default settings. To view the following window, click Tools > Reset, as shown below: Figure 13-17 Reset Window Select one of the following options:  The Switch will reset to its factory default settings and then reboot.  The Switch will reset to its factory default settings and then reboot. This option excludes the IP address. 353