D-Link DGS-3130 User Manual - Page 189
IPv4 Route Table
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide The Switch also supports a floating static route, which means that the user may create an alternative static route with a different next hop. This secondary next hop device route is considered as a backup static route when the primary static route is down. If the primary route is lost, the backup route will become active and begin forwarding traffic. Entries into the Switch's forwarding table can be made using an IP address, subnet mask and gateway. To view the following window, click L3 Features > IPv4 Static/Default Route, as shown below: Figure 6-20 IPv4 Static/Default Route Window The fields that can be configured are described below: Parameter IP Address Mask IP Tunnel Gateway Null Interface Backup State Description Enter the IPv4 address for this route here. Tick the Default Route option to use the default route as the IPv4 address. Enter the IPv4 network mask for this route here. Select the IP Tunnel option to use the IP tunnel feature and enter the tunnel ID in the space provided. The range of IDs is from 0 to 9999. Enter the gateway address for this route here. Select to enable or disable the NULL interface here. Select the backup state option here. Weight - Specifies a weight number greater than zero, but less than the maximum paths number. This number is used to replicate identical route paths (multiple copies) in the routing table, so the paths get more chance of being hit for traffic routing. If the weight number is not specified for the static route, the default for the path exists in the hashing table. Enter the weight value in the space provided. The range is from 1 to 64. Click the Apply button to accept the changes made. Click the Delete button to remove the specific entry. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. IPv4 Route Table This window is used to display and configure the IPv4 route table settings. To view the following window, click L3 Features > IPv4 Route Table, as shown below: 179