Dell PowerEdge 2970 Hardware Owner's Manual - Page 112
Installing the System Board
View all Dell PowerEdge 2970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Figure 3-35. System Board Removal 1 2 3 4 1 system-board tray riser release pin 4 system-board securing tabs 2 system board 3 system-board tray Installing the System Board CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge. 1 Lower the system-board tray until the tray sits flat on the bottom of the chassis. 2 Align the back connectors on the system board with the cutouts in the back of the chassis, and ensure the system-board tray is square with the chassis so that the securing tabs on the chassis fully insert into system-board securing slots. See Figure 3-35. 3 Slide the system-board tray toward the back of the chassis until it locks into position. 4 Replace the sideplane. See "Installing the Sideplane Board" on page 107 112 Installing System Components