Dell PowerEdge 2970 Hardware Owner's Manual - Page 83
Installing the Optical Drive, Removing the Optical Drive From the Optical Drive Tray
View all Dell PowerEdge 2970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Installing the Optical Drive 1 Align the optical drive tray with its opening in the front panel. See Figure 3-19. 2 Slide in the drive tray until the tray snaps into place. 3 Connect the optical drive cable and the power cable to the back of the drive tray. 4 Close the system. See "Closing the System" on page 56. 5 Replace the bezel. See "Replacing the Front Bezel" on page 55. 6 Reconnect your system and peripherals to their electrical outlets, and turn on the system. Removing the Optical Drive From the Optical Drive Tray 1 Pull outward on the interposer board release tab at the back of the drive tray to release the interposer board connected to the optical drive. See Figure 3-20. 2 Pull the interposer board connector from the optical drive connector and rotate the interposer board outward from the tray. 3 Pull outward again on the interposer board release tab and simultaneously pull up on the left side of the optical drive to separate the drive from the tray. See Figure 3-20. Figure 3-20. Removing and Installing the Optical Drive in the Optical Drive Carrier 3 4 5 2 1 1 optical drive carrier 4 optical drive connector 2 optical drive 5 interposer board 3 interposer-board release tab Installing System Components 83