Dell PowerEdge 2970 Hardware Owner's Manual - Page 31
See Using the System Setup, See Using the System Setup Program - not detecting memory
View all Dell PowerEdge 2970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Table 1-7. System Messages (continued) Message Causes Corrective Actions Manufacturing mode detected System is in manufacturing mode. Reboot to take the system out of manufacturing mode. Memory address line failure at address, read value expecting value Faulty or improperly installed memory See "Troubleshooting System Memory" modules. on page 124. Memory double word logic failure at address, read value expecting value Memory odd/even logic failure at address, read value expecting value Memory write/read failure at address, read value expecting value Memory tests terminated by POST memory test terminated by keystroke. pressing the spacebar. Information only. No boot device available Faulty or missing optical/diskette drive subsystem, hard drive, or harddrive subsystem, or no boot disk in drive A. Use a bootable diskette, CD, or hard drive. If the problem persists, see "Troubleshooting a Diskette Drive" on page 126, "Troubleshooting an Optical Drive" on page 127, and "Troubleshooting a Hard Drive" on page 129. See "Using the System Setup Program" on page 37 for information on setting the order of boot devices. No boot sector on hard drive Incorrect configuration settings in System Setup program, or no operating system on hard drive. Check the hard-drive configuration settings in the System Setup program. See "Using the System Setup Program" on page 37. If necessary, install the operating system on your hard drive. See your operating system documentation. No timer tick interrupt Faulty system board. See ""Getting Help" on page 147." Not a boot diskette No operating system on diskette. Use a bootable diskette. PCI BIOS failed to install PCIe device BIOS (Option ROM) checksum failure detected during shadowing. Cables to expansion card(s) loose; faulty or improperly installed expansion card(s). Reseat the expansion card(s). Ensure that all appropriate cables are securely connected to the expansion card(s). If the problem persists, see "Troubleshooting Expansion Cards" on page 132. About Your System 31