Dell PowerEdge 2970 Hardware Owner's Manual - Page 75
Installing the Cooling Shroud
View all Dell PowerEdge 2970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Figure 3-15. Removing and Installing the Cooling Shroud 2 3 1 4 5 1 shroud pivots (2) 4 shroud hinges (2) 2 cooling shroud 5 fan bracket 3 cable tabs Installing the Cooling Shroud 1 Align the hinges on the shroud with the pivots located on each end of the fan bracket. See Figure 3-15. 2 Lower the shroud straight down into the system until the hinges snap into place on the pivots. 3 Rotate the shroud down over the processor(s) and memory modules. 4 Route the optical drive cable through the cable tabs on top of the cooling shroud. 5 Reinstall the left riser board. See "Installing the Left Riser Board" on page 103. 6 Reinstall the expansion cards into the left riser board. "Installing an Expansion Card" on page 72. 7 Close the system. See "Closing the System" on page 56. 8 Reconnect the system to the electrical outlet and turn on the system and attached peripherals. Installing System Components 75