Dell PowerEdge 2970 Hardware Owner's Manual - Page 80
Pull back slightly on one of the blue retention standoff tabs and gently work the edge of RAC card off
View all Dell PowerEdge 2970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Figure 3-18. Installing and Removing a RAC Card 3 4 2 1 7 5 6 1 RAC-card connectors (2) 4 RAC card 7 support standoffs (2) 2 RAC-card cables (2) 5 retention standoff 3 retention standoff hole 6 support standoff holes (2) 5 Pull back slightly on one of the blue retention standoff tabs and gently work the edge of RAC card off of the standoff. Repeat for the other retention standoff. 6 Angle the free end of the RAC card up and pull the card away from the support standoffs. 7 If you are not replacing the RAC card, disconnect and remove the ribbon cables from the system board and close the system. See "Closing the System" on page 56. NOTICE: When detaching the RAC cables from the system board, squeeze the metal ends of the cable connectors and gently work the connector out of the socket. Do not pull on the cable to unseat the connector. Doing so can damage the cable. 80 Installing System Components