Dell PowerEdge 2970 Hardware Owner's Manual - Page 29
Table 1-7., System Messages, Message, Causes, Corrective Actions, Caution! NVRAM_CLR jumper - bios update
View all Dell PowerEdge 2970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Table 1-7. System Messages Message Causes Corrective Actions Alert! Node interleaving disabled! Memory configuration does not support node interleaving. The memory configuration does not Ensure that the memory modules are support node interleaving, or the installed in a configuration that supports configuration has changed (for node interleaving. Check other system example, a failed DIMM) so that node messages for additional information for interleaving cannot be supported. possible causes. For memory The system will run but with reduced configuration information, see "General functionality. Memory Module Installation Guidelines" on page 91. If the problem persists, see "Troubleshooting System Memory" on page 124. Attempting to update Remote Configuration. Please wait... Remote Configuration request has Wait until the process is complete. been detected and is being processed. BIOS Update Attempt Failed! Remote BIOS update attempt failed. Retry the BIOS update. If problem persists, see "Getting Help" on page 147. Caution! NVRAM_CLR jumper NVRAM_CLR jumper is installed. is installed on system CMOS has been cleared. board. Remove NVRAM_CLR jumper. See Figure 6-1 for jumper location. CPUs with different cache sizes detected! Microprocessors with different cache sizes are installed. Ensure that all microprocessors have the same cache size and that they are properly installed. See "Processors" on page 96. Decreasing available memory Faulty or improperly installed memory See "Troubleshooting System Memory" modules. on page 124. Diskette drive n seek failure Incorrect configuration settings in the Run the System Setup program to System Setup program. correct the settings. See "Using the System Setup Program" on page 37. Faulty or improperly installed diskette Replace the diskette. If the problem drive. persists, see "Troubleshooting a Diskette Drive" on page 126. Loose diskette drive interface cable, or Reseat diskette drive interface cable, or loose power cable. power cable. If the problem persists, see "Troubleshooting a Diskette Drive" on page 126. Diskette read failure Faulty or improperly inserted diskette. Replace the diskette. See "Troubleshooting a Diskette Drive" on page 126. About Your System 29