Epson Stylus Pro 9000 User Manual - Page 16

Ink Cartridge Safety Instructions, does get on your skin - rip

Get Epson Stylus Pro 9000 - Print Engine PDF manuals and user guides View all Epson Stylus Pro 9000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

Introduction | 7 • If you use an extension cord with the printer, make sure the total ampere rating of the devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's ampere rating. • Except as specifically explained in the documentation, do not attempt to service the printer (or RIP Station 5100) yourself. Opening or removing those covers that are marked "Do Not Remove" may expose you to dangerous voltage points or other risks. Refer all servicing in those compartments to service personnel. • Power down the printer from the control panel, unplug the printer (or RIP Station 5100) and refer servicing to qualified service personnel under the following conditions: If the power cord or plug is damaged; if liquid has entered the printer (or RIP Station 5100); if the equipment has been dropped or the case damaged; if the printer (or RIP Station 5100) does not operate normally or exhibits a distinct change in performance. Adjust only those controls that are covered by the operating instructions. Ink Cartridge Safety Instructions • Do not put your hand inside the printer or touch the cartridges during printing. • To avoid damaging the printer, do not move the print head by hand. • Under normal circumstances, ink will not come out of the cartridge. If it does get on your skin, wash it off with soap and water. If it gets in your eyes, flush them immediately with water. • Keep ink cartridges out of the reach of children and do not drink the ink. • Do not store ink cartridges at high or freezing temperatures. Keep cartridges away from direct sunlight. • Do not dismantle the ink cartridges or try to refill them. This could result in damage to the print head. • Install the ink cartridge immediately after you remove it from its package. Leaving the cartridge unpacked for a long time before use may result in reduced print quality. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
7
Introduction
|
7
•
If you use an extension cord with the printer, make sure the total ampere
rating of the devices plugged into the extension cord does not exceed the
cord’s ampere rating. Also, make sure the total ampere rating of all
devices plugged into the wall outlet does not exceed the wall outlet’s
ampere rating.
•
Except as specifically explained in the documentation, do not attempt to
service the printer (or RIP Station 5100) yourself. Opening or removing
those covers that are marked “Do Not Remove” may expose you to
dangerous voltage points or other risks. Refer all servicing in those
compartments to service personnel.
•
Power down the printer from the control panel, unplug the printer (or
RIP Station 5100) and refer servicing to qualified service personnel
under the following conditions:
If the power cord or plug is damaged; if liquid has entered the printer
(or RIP Station 5100); if the equipment has been dropped or the case
damaged; if the printer (or RIP Station 5100) does not operate normally
or exhibits a distinct change in performance. Adjust only those controls
that are covered by the operating instructions.
Ink Cartridge Safety Instructions
•
Do not put your hand inside the printer or touch the cartridges during
printing.
•
To avoid damaging the printer, do not move the print head by hand.
•
Under normal circumstances, ink will not come out of the cartridge. If it
does get on your skin, wash it off with soap and water. If it gets in your
eyes, flush them immediately with water.
•
Keep ink cartridges out of the reach of children and do not drink the
ink.
•
Do not store ink cartridges at high or freezing temperatures. Keep
cartridges away from direct sunlight.
•
Do not dismantle the ink cartridges or try to refill them. This could
result in damage to the print head.
•
Install the ink cartridge immediately after you remove it from its
package. Leaving the cartridge unpacked for a long time before use may
result in reduced print quality.