IBM x3655 Service Guide - Page 101
Installing, power, backplane
![]() |
UPC - 883436014533
View all IBM x3655 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Installing the power backplane To install the replacement power backplane, complete the following steps. Power backplane connector 1. Align the edge-connector of the power backplane with the power-backplane edge-connector on the system board. 2. Slide the power backplane toward the left side of the server until the edge-connectors are fully connected. 3. Connect the power cable from the hard disk drive backplane to the power backplane. 4. Install the fan-bracket assembly (see "Installing the fan-bracket assembly" on page 67). 5. Install the cover (see "Installing the cover" on page 40). 6. Install the power supplies into the power-supply bays (see "Installing a hot-swap power supply" on page 69). 7. Slide the server into the rack. 8. Connect the cables and power cords. Chapter 3. Removing and replacing server components 83
![](/manual_guide/products/ibm-x3655-service-guide-079be7e/101.png)