IBM x3655 Service Guide - Page 22
Features, specifications
UPC - 883436014533
View all IBM x3655 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Features and specifications The following information is a summary of the features and specifications of the server. Depending on the server model, some features might not be available, or some specifications might not apply. Table 1. Features and specifications Microprocessor: v AMD Opteron dual-core with 2 MB (1 MB per core) Level-2 Cache v 1 GHz Hypertransport interconnect bus v Support for up to two microprocessors Note: Use the Configuration/Setup Utility program to determine the type and speed of the microprocessors. Memory: v Sixteen DIMM connectors v Minimum: 1 GB v Maximum: 64 GB v Type: Registered PC2-5300 double data rate (DDR) II, DIMMs v Sizes: 512 MB, 1 GB, 2 GB, or 4 GB, in pairs Drives: (depending on your model) v Hard disk drive: SAS or SATA v One of the following IDE drives: - DVD-ROM - CD-RW/DVD-ROM combination Expansion bays: v Hot-swap hard disk drive bays: One of the following configurations: - Six 3.5-inch drive bays (optional tape drive will require two of these bays) - Eight 2.5-inch drive bays and one tape drive bay v One 5.25-inch Ultrabay Enhanced bay (CD-RW/DVD-ROM drive installed) Expansion slots: v Three low-profile PCI Express slots (two x8 and one x4 lanes) on the system board v Support for one of the following riser cards: - HTX riser card with a full height, full length HTX adapter slot (25 W max.) (standard) - PCI Express riser card with a full height, full length adapter slot (x16 lanes) (25 W max.) (optional) - PCI-X riser card with one full length, full height 133 MHz/64-bit adapter slot (optional) Hot-swap fans: v Standard: Five v Maximum: Ten - provide redundant cooling Hot-swap power supplies: Environment: v Air temperature: 835 watts (100-240 V ac) - Server on: 10° to 35°C (50.0° to v Minimum: One 95.0°F); altitude: 0 to 914.4 m (3000 v Maximum: Two - provide redundant ft). Decrease system temperature by power 0.75°C for every 1000-foot increase in Size (2 U): v Height: 85.4 mm (3.36 in.) v Depth: 698 mm (27.48 in.) v Width: 443.6 mm (17.5 in.) v Weight: approximately 21.09 kg (46.5 lb) to 29.03 kg (64 lb) depending upon configuration altitude. - Server off: 10° to 43°C (50.0° to 109.4°F); maximum altitude: 2133 m (7000 ft) - Shipment: -40° to +60°C (-40° to 140°F); maximum altitude: 2133 m (7000 ft) v Humidity: Integrated functions: v Baseboard management controller or - Server on/off: 8% to 80% - Shipment: 5% to 100% on-board service processor v Two Broadcom 10/100/1000 Ethernet Heat output: controllers with Wake on LAN®support and TCPIP Offload Engine (TOE) support v One serial port v One serial-attached SCSI (SAS) controller v Six Universal Serial Bus (USB) ports Approximate heat output in British thermal units (Btu) per hour: v Minimum configuration: 1230 Btu (360 watts) v Maximum configuration: 2840 Btu (830 watts) (2.0) Electrical input: - Two on the front of the server v Sine-wave input (50-60 Hz) required - Four on the rear of the server v Input voltage range automatically selected v Two video ports v Input voltage low range: - One on the front of the server - Minimum: 100 V ac - One on the rear of the server - Maximum: 127 V ac v Support for Remote Supervisor Adapter v Input voltage high range: II SlimLine - Minimum: 200 V ac Video controller: v ATI RN50 video on system board v Compatible with SVGA and VGA v 16 MB DDR video memory - Maximum: 240 V ac v Input kilovolt-amperes (kVA) approximately: - Minimum: 0.36 kVA - Maximum 0.93 kVA RAID controller: Notes: v ServeRAID-8k-l SAS Controller, 256 1. Power consumption and heat output MB, that supports RAID levels 0, 1, 10 vary depending on the number and type (standard) of optional features that are installed and v Upgradable to ServeRAID-8k SAS Controller, 512 MB with battery backup, the power-management optional features in use. that supports additional RAID levels 2. These levels were measured in Acoustical noise emissions: v Declared sound power, idle: 6.8 bel v Declared sound power, operating: 6.8 bel controlled acoustical environments according to the procedures that are specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO average values stated because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computer will operate. 4 IBM System x3655 Type 7985: Problem Determination and Service Guide