IBM x3655 Service Guide - Page 78
connectors.
![]() |
UPC - 883436014533
View all IBM x3655 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
1. Remove the tape drive and the cable from their static-protective package. 2. If the tape drive assembly has a space filler on top of the drive, remove it now. 3. From the inside of the server, thread the tape-drive end of the cable for your tape drive through the rear of the tape drive bay and out the front of the server. 4. Connect the cable to the back of the tape drive. 5. Push the tape drive assembly into the tape drive bay, gently pulling the cable farther into the server as you do so, until the tape drive assembly stops. 6. Push the tray handle to the closed (locked) position. 7. Connect the cable to the following system-board connectors (see ″System-board internal connectors″ on page 11 for the location of the connectors). v Signal connector: SATA tape drive signal connector J36 v Power connector: Tape drive power connector J22 The following illustration shows the routing of the SATA tape drive signal cable. Important: Make sure that the cables avoid any fan connectors. 60 IBM System x3655 Type 7985: Problem Determination and Service Guide
![](/manual_guide/products/ibm-x3655-service-guide-079be7e/78.png)