IBM x3655 Service Guide - Page 84
Removing, fan-bracket, assembly
![]() |
UPC - 883436014533
View all IBM x3655 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Hot-swap fan 1. Orient the new fan over its position in the fan assembly bracket so that the LED on top of the fan is toward the left side of the server. 2. Push the fan into the fan bracket assembly until it clicks into place. 3. Repeat until all the new or replacement fans are installed. 4. Install the cover (see "Installing the cover" on page 40). 5. Slide the server into the rack. Removing the fan-bracket assembly To replace some components, such as the CD-RW/DVD drive, you must remove the fan-bracket assembly; to route some cables, you might have to remove the fan-bracket assembly. Note: To remove or install a fan, it is not necessary to remove the fan-bracket assembly. See "Removing a hot-swap fan" on page 64 and "Installing a hot-swap fan" on page 65. Fan bracket release latches Fan bracket To remove the fan-bracket assembly, complete the following steps: 1. Read the safety information that begins on page vii and "Installation guidelines" on page 35. 66 IBM System x3655 Type 7985: Problem Determination and Service Guide
![](/manual_guide/products/ibm-x3655-service-guide-079be7e/84.png)