IBM x3655 Service Guide - Page 87
Installing, hot-swap, power, supply
UPC - 883436014533
View all IBM x3655 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Installing a hot-swap power supply The server supports a maximum of two hot-swap power supplies. Important: Only the configurations shown in the following table are supported: Installed power supplies Power supply 1 Power supplies 1 and 2 Required fans Fans in locations 3, 4, 8, 9, and 10 All 10 fans Statement 8: CAUTION: Never remove the cover on a power supply or any part that has the following label attached. Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician. Hot-swap power supply 2 Power supply filler release lever Power supply filler Attention: During normal operation, each power-supply bay must have either a power supply or power-supply blank installed for proper cooling. Chapter 3. Removing and replacing server components 69