IBM x3655 Service Guide - Page 85
Installing, fan-bracket, assembly
![]() |
UPC - 883436014533
View all IBM x3655 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
2. Turn off the server and all attached devices. 3. Disconnect all external cables and power cords. 4. Slide the server out of the rack. 5. Remove the cover (see "Removing the cover" on page 39). 6. Place your thumbs on the metal tabs of the fan-bracket-assembly levers and pinch the tab and blue release latch together; then, raise the levers, raising the fan-bracket assembly. 7. Grasp the levers and lift the fan-bracket assembly out of the server. 8. If you are instructed to return the fan-bracket assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you. Installing the fan-bracket assembly To install the replacement fan-bracket assembly, complete the following steps. Fan bracket release latches Fan bracket 1. Align the guides on the left and right sides of the assembly with the slots in the sides of the chassis. 2. Lower the fan-bracket assembly into the chassis. 3. Push the fan-bracket-assembly levers toward the rear of the server until they stop; pinch the release latches and metal tabs together and push the levers down into place. 4. Press down on the lever metal tabs and on the fans to be sure the fan-bracket assembly is fully seated. 5. Install the cover (see "Installing the cover" on page 40). 6. Slide the server into the rack. 7. Connect the cables and power cords. 8. Turn on all attached devices and the server. Chapter 3. Removing and replacing server components 67
![](/manual_guide/products/ibm-x3655-service-guide-079be7e/85.png)