IBM x3655 Service Guide - Page 93
Installing, operator, information, panel, assembly
![]() |
UPC - 883436014533
View all IBM x3655 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
10. If you are instructed to return the operator information panel assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you. Installing the operator information panel assembly Ribbon cable Release tabs Operator information panel Operator information panel Release latch To install the replacement operator information panel assembly, complete the following steps: 1. From the front of the server, thread the operator-information-panel ribbon cable through the panel housing in the server; then, connect the ribbon cable to the operator-panel connector (J76) on the system board (see "System-board internal connectors" on page 11 for the location of the connector). 2. Slide the panel into the server until it clicks into place. 3. Inside the server, secure the ribbon cable to the top of the panel enclosure using the velcro fastener. 4. Install the cover (see "Installing the cover" on page 40). 5. Slide the server into the rack. 6. Connect the cables and power cords. Chapter 3. Removing and replacing server components 75
![](/manual_guide/products/ibm-x3655-service-guide-079be7e/93.png)