Netgear SRX5308 SRX5308 Reference Manual - Page 172

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual 2. Click the VPN Policies submenu tab. The VPN Policies screen displays. (Figure 5-22 shows some examples.) Figure 5-22 Each policy contains the data that are explained in Table 5-11. These fields are explained in more detail in Table 5-12 on page 5-33. Table 5-11. List of VPN Policies Information Item ! (Status) Name Type Local Remote Description (or Subfield and Description) Indicates whether the policy is enabled (green circle) or disabled (gray circle). To enable or disable a policy, select the check box adjacent to the circle and click the Enable or Disable table button, as appropriate. The name that identifies the VPN policy. When you use the VPN Wizard to create a VPN policy, the name of the VPN policy (and of the automatically created accompanying IKE policy) is the connection name. Auto or Manual as described previously (Auto is used during VPN Wizard configuration). IP address (either a single address, range of addresses, or subnet address) on your LAN. Traffic must be from (or to) these addresses to be covered by this policy. (The subnet address is supplied as the default IP address when you are using the VPN Wizard). IP address or address range of the remote network. Traffic must be to (or from) these addresses to be covered by this policy. (The VPN Wizard default requires the remote LAN IP address and subnet mask.) 5-30 Virtual Private Networking Using IPsec Connections v1.0, April 2010