Netgear SRX5308 SRX5308 Reference Manual - Page 47

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual Configuring Protocol Binding (Optional) To configure protocol binding and add protocol binding rules: 1. Select Network Configuration > Protocol Binding from the menu. 2. Select the Load Balancing radio button. The Protocol Bindings screen displays. (Figure 2-16 shows two examples in the Protocol Binding table.) Figure 2-16 The Protocol Binding table displays the following fields: • Check box. Allows you to select the protocol binding rule in the table. • Status icon. Indicates the status of the protocol binding rule: - Green circle. The protocol binding rule is enabled. - Gray circle. The protocol binding rule is disabled. • Service. The service or protocol for which the protocol binding rule is set up. • Local Gateway. The WAN interface to which the service or protocol is bound. • Source Network. The computers on your network that are affected by the protocol binding rule. • Destination Network. The Internet locations (based on their IP address) that are covered by the protocol binding rule. • Action. The Edit button provides access to the Edit Protocol Binding screen for the corresponding service. 3. Click the Add table button below the Protocol Binding table. The Add Protocol Binding screen displays (see Figure 2-17 on page 2-24). Connecting the VPN Firewall to the Internet v1.0, April 2010 2-23