Netgear SRX5308 SRX5308 Reference Manual - Page 343

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual Table C-9. System Logs: Unicast, Redirect (continued) Recommended Action To enable these logs, from the CLI command prompt of the router, enter this command: monitor/firewallLogs/logger/loggerConfig logIcmpRedirect 1 And to disable it enter: monitor/firewallLogs/logger/loggerConfig logIcmpRedirect 0 Multicast/Broadcast Logs Table C-10. System Logs: Multicast/Broadcast Message Jan 1 07:24:13 [SRX5308] [kernel] MCAST-BCAST IN=WAN OUT=SELF SRC=192.168.1.73 DST=192.168.1.255 PROTO=UDP SPT=138 DPT=138 Explanation • This packet (Broadcast) is sent to the device from the WAN network. • For other settings, see Table C-1. Recommended Action None WAN Status This section describes the logs generated by the WAN component. If there are several ISP links for Internet connectivity, the VPN firewall can be configured either in auto-rollover or load balancing mode. Load Balancing When the WAN mode is configured for load balancing, all the WAN ports are active simultaneously and the traffic is balanced between them. If one WAN link goes down, all the traffic is diverted to the other WAN links that are active. This section describes the logs generated when the WAN mode is set to load balancing. Table C-11. System Logs: WAN Status, Load Balancing Message Dec 1 12:11:27 [SRX5308] [wand] [LBFO] Restarting WAN1_ Dec 1 12:11:31 [SRX5308] [wand] [LBFO] Restarting WAN2_ Dec 1 12:11:35 [SRX5308] [wand] [LBFO] WAN1(UP), WAN2(UP)_ Dec 1 12:24:12 [SRX5308] [wand] [LBFO] WAN1(UP), WAN2(DOWN)_ Dec 1 12:29:43 [SRX5308] [wand] [LBFO] Restarting WAN2_ Dec 1 12:29:47 [SRX5308] [wand] [LBFO] WAN1(UP), WAN2(DOWN)_ System Logs and Error Messages C-5 v1.0, April 2010