Netgear SRX5308 SRX5308 Reference Manual - Page 71
Configuring VLAN MAC Addresses and LAN Advanced Settings, Apply, Network Configuration, LAN Settings - vlan setup
![]() |
UPC - 606449065145
View all Netgear SRX5308 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual 4. Click Apply to save your settings. Note: Once you have completed the LAN setup, all outbound traffic is allowed and all inbound traffic is discarded except responses to requests from the LAN side. For information about how to change these default traffic rules, see Chapter 4, "Firewall Protection." Note: For information about the DHCP log, see "Viewing the DHCP Log" on page 9-24. Configuring VLAN MAC Addresses and LAN Advanced Settings By default, all configured VLAN profiles share the same single MAC address as the LAN ports. (All LAN ports share the same MAC address). However, you can change the VLAN MAC settings to allow up to 16 VLANs to each be assigned a unique MAC address. You can also enable or disable the broadcast of Address Resolution Protocol (ARP) packets for the default VLAN. If the broadcast of ARP packets is enabled, IP addresses can be mapped to physical addresses (that is, MAC addresses). To configure a VLAN to have a unique MAC address: 1. Select Network Configuration > LAN Settings from the menu. The LAN submenu tabs display, with the LAN Setup screen in view (see Figure 3-2 on page 3-6). LAN Configuration v1.0, April 2010 3-11
![](/manual_guide/products/netgear-srx5308-srx5308-reference-manual-43ed089/71.png)