Garmin GPSMAP 296 Pilot's Guide - Page 154
Messages, Boat Is Not Moving Fast Enough to Calibrate - internal battery
View all Garmin GPSMAP 296 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
APPENDIX > MESSAGES Messages Accuracy Alarm-the GPS accuracy has fallen outside of user-set value. Alarm Clock-the alarm clock has sounded. Antenna Shorted to Ground-the external GPS antenna has an electrical connection problem. Contact Garmin Product Support. Approaching Target Altitude-within 1,000 feet of final VNAV target altitude. Approaching Turn-you are nearing a turn in a route. Approaching VNAV Profile-you are within one minute of reaching the initial VNAV decent point. Arriving at Destination-you are nearing your destination. Batteries Low-the battery needs to be recharged. Basemap Failed Unit Needs Repair-there is an internal problem with your unit. Contact Garmin Product Support to have the unit serviced. Boat Is Not Moving Fast Enough to Calibrate-the boat is not moving fast enough for the speed wheel to provide a valid speed. Can't Unlock Maps-no applicable unlock code for one or more maps was found. All MapSource maps are not accessible. Database Error-internal problem with the unit. Contact your dealer or Garmin Product Support to have the unit repaired. Deep Water-the water is deeper than the amount set in the Deep Water Alarm. Detail Maps Don't Support Routing-maps that are loaded on the data card do not support automatic route calculation. Distress Call-a DSC distress call was received. Take appropriate action. Dragging Anchor-the distance set in the Anchor Drag Alarm is exceeded. Drift Alarm-the water depth has changed by the amount entered in the Drift Alarm setup. Fish Alarm-a fish was detected. The unit shows an icon and beeps (if enabled). This alarm does not show a message banner. Lost Satellite Reception-the unit is unable to receive satellite signals. Memory Full-unit memory is full, no further data can be saved. Memory (RAM) Failed Unit Needs Repair-there is an internal problem with your unit. Contact Garmin Product Support to have the unit serviced. Memory (ROM) Failed Unit Needs Repair-there is an internal problem with your unit. Contact Garmin Product Support to have the unit serviced. Near Proximity Point-you have reached the distance set for a proximity waypoint. NMEA Depth is Below Transducer-no keel offset value has been received from the external sonar device. No Diff GPS Location-RTCM is selected, but the unit is not receiving DGPS data. No Roads Near Destination-the destination for the road route you tried to calculate is not near any roads. Select a different destination. 146 GPSMAP 296 Pilot's Guide