HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 2 - LAN Switching Co - Page 113

Description Use reset stp to clear the MSTP statistics. The MSTP statistics include the numbers of TCN BPDUs, configuration BPDUs, RST BPDUs and MST BPDUs sent/received through the specified ports. The STP BPDUs and TCN BPDUs are counted only for the CIST. If you specify the interface-list argument, the reset stp command clears the spanning tree-related statistics on the specified ports. Without the argument, the reset stp command clears the spanning tree-related statistics on all ports. Related commands: display stp. Examples # Clear the spanning tree-related statistics on ports GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3. reset stp interface gigabitethernet 1/0/1 to gigabitethernet 1/0/3 revision-level Syntax revision-level level View undo revision-level MST region view Default level 2: System level Parameters level: Specifies an MSTP revision level, in the range of 0 to 65535. Description Use revision-level to configure the MSTP revision level. Use undo revision-level to restore the default MSTP revision level. By default, the MSTP revision level is 0. The MSTP revision level, the MST region name, and the VLAN-to-instance mapping table of a device determine the device's MST region. When the MST region name and VLAN-to-instance mapping table are both the same for two MST regions, they can still be differentiated by their MSTP revision levels. After configuring this command, run the active region-configuration command to activate the configured MST region level. Related commands: instance, region-name, vlan-mapping modulo, display stp region-configuration, check region-configuration, and active region-configuration. Examples # Set the MSTP revision level of the MST region to 5. system-view [Sysname] stp region-configuration [Sysname-mst-region] revision-level 5 105