HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 2 - LAN Switching Co - Page 157

[Sysname-GigabitEthernet1/0/1] port link-type trunk [Sysname-GigabitEthernet1/0/1] port trunk permit vlan 2 4 50 to 100 Please wait........... Done. # Assign the trunk Layer 2 aggregate interface Bridge-Aggregation 1 to VLAN 2. system-view [Sysname] interface bridge-aggregation 1 [Sysname-Bridge-Aggregation1] port link-type trunk [Sysname-Bridge-Aggregation1] port trunk permit vlan 2 Please wait... Done. Configuring GigabitEthernet1/0/1... Done. Configuring GigabitEthernet1/0/2... Done. Configuring GigabitEthernet1/0/3... Done. The output shows that GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3 are the member ports of the aggregation group corresponding to Bridge-Aggregation 1. port trunk pvid Syntax port trunk pvid vlan vlan-id View undo port trunk pvid Layer 2 Ethernet interface view, Layer 2 aggregate interface view Default level 2: System level Parameters vlan-id: Specifies a VLAN ID, in the range of 1 to 4094 Description Use port trunk pvid to configure the PVID for the trunk port. Use undo port trunk pvid to restore the default. By default, the PVID of a trunk port is VLAN 1. You can use a nonexistent VLAN as the PVID for a trunk port. If you use the undo vlan command to remove the PVID of a hybrid port, it does not affect the setting of the PVID on the port. The configuration made in Layer 2 Ethernet interface view applies only to the port. The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its aggregation member ports. • If the system fails to apply the configuration to the aggregate interface, it stops applying the configuration to aggregation member ports. • If the system fails to apply the configuration to an aggregation member port, it skips the port and moves to the next member port. The local and remote trunk ports must use the same PVID for the traffic of the PVID to be transmitted properly. 149