HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 2 - LAN Switching Co - Page 223
lldp admin-status, lldp check-change-interval
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 223 highlights
Field LLDP-MED extend TLV Description LLDP-MED TLVs: • Capabilities TLV • Network Policy TLV • Extended Power-via-MDI TLV • Location Identification TLV • Inventory TLV, including hardware revision TLV, firmware revision TLV, software revision TLV, serial number TLV, manufacturer name TLV, model name TLV, and asset id TLV lldp admin-status Syntax lldp admin-status { disable | rx | tx | txrx } View undo lldp admin-status Layer 2 Ethernet interface view Default level 2: System level Parameters disable: Specifies the Disable mode. A port in this mode does not send or receive LLDPDUs. rx: Specifies the Rx mode. A port in this mode only receives LLDPDUs. tx: Specifies the Tx mode. A port in this mode only sends LLDPDUs. txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDPDUs. Description Use lldp admin-status to specify the LLDP operating mode for a port. Use undo lldp admin-status to restore the default LLDP operating mode. By default, the LLDP operating mode is TxRx. Examples # Configure the LLDP operating mode as Rx for GigabitEthernet 1/0/1. system-view [Sysname] interface gigabitethernet 1/0/1 [Sysname-GigabitEthernet1/0/1] lldp admin-status rx lldp check-change-interval Syntax lldp check-change-interval interval undo lldp check-change-interval 215