HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 2 - LAN Switching Co - Page 205
qinq transparent-vlan, Indicates all VLANs.
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 205 highlights
Description Use qinq ethernet-type service-tag to configure the TPID value in SVLAN tags. Use undo qinq ethernet-type service-tag to restore the TPID value in SVLAN tags to the default setting. By default, the TPID value in SVLAN tags is 0x8100. On a port with basic QinQ not enabled, the switch judges whether a frame is VLAN tagged based on the SVLAN TPID value on the port. Configured in Ethernet interface view, this command takes effect on the current port only. Configured in Layer 2 aggregate interface view, this command takes effect on the Layer 2 aggregate interface and the member ports in its aggregation group. Examples # Set the TPID value in the SVLAN tags to 0x9100 on GigabitEthernet 1/0/1. system-view [Sysname] interface gigabitethernet 1/0/1 [Sysname-GigabitEthernet1/0/1] qinq ethernet-type service-tag 9100 qinq transparent-vlan Syntax qinq transparent-vlan vlan-list View undo qinq transparent-vlan { all | vlan-list } Layer 2 Ethernet interface view, Layer 2 aggregate interface view Default level 2: System level Parameters vlan-list: Specifies a list of existing VLANs in the format of vlan-list = { vlan-id1 [ to vlan-id2 ] }&, where vlan-id1 and vlan-id2 represent the VLAN IDs and each range from 1 to 4094, vlan-id2 cannot be smaller than vlan-id1, and & indicates that you can specify up to 10 vlan-id1 [ to vlan-id2 ] parameters. all: Indicates all VLANs. Description Use qinq transparent-vlan to configure VLAN transparent transmission on one or multiple ports, so the port or ports can transparently transmit frames from the specified VLANs. Use undo qinq transparent-vlan to remove the configuration. By default, VLAN transparent transmission is not configured on ports. Configured in Layer 2 Ethernet interface view, the command takes effect on the interface only. Configured in Layer 2 aggregate interface view, the command takes effect on the Layer 2 aggregate interface and all the member ports in the aggregation group. Examples # Enable basic QinQ on GigabitEthernet 1/0/1, and configure GigabitEthernet 1/0/1 to transparently transmit frames from VLAN 2, VLAN 3, and VLAN 50 through VLAN 100. 197