HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 2 - LAN Switching Co - Page 44
storm-constrain interval, unicast-suppression
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Examples # Disable GigabitEthernet 1/0/1 from sending out storm control threshold event traps. system-view [Sysname] interface gigabitethernet 1/0/1 [Sysname-GigabitEthernet1/0/1] undo storm-constrain enable trap storm-constrain interval Syntax storm-constrain interval seconds View undo storm-constrain interval System view Default level 2: System level Parameters seconds: Sets the traffic polling interval of the storm control module, ranging from 1 to 300 seconds. Description Use storm-constrain interval to set the traffic polling interval of the storm control module. Use undo storm-constrain interval to restore the default. By default, the storm control module polls traffic statistics every 10 seconds. For network stability, use the default or a higher polling interval. NOTE: The interval set by the storm-constrain interval command is specific to storm control. To set the statistics polling interval of an interface, use the flow-interval command. Examples # Set the traffic statistics polling interval of the storm control module to 60 seconds. system-view [Sysname] storm-constrain interval 60 unicast-suppression Syntax unicast-suppression { ratio | pps max-pps | kbps max-kbps } View undo unicast-suppression Ethernet interface view Default level 2: System level 36