HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 2 - LAN Switching Co - Page 224
lldp compliance admin-status cdp
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 224 highlights
View Layer 2 Ethernet interface view Default level 2: System level Parameters interval: Sets the LLDP polling interval, ranging from 1 to 30 seconds. Description Use lldp check-change-interval to enable LLDP polling and set the polling interval. Use undo lldp check-change-interval to restore the default. By default, LLDP polling is disabled. Examples # Enable LLDP polling on GigabitEthernet 1/0/1, setting the polling interval to 30 seconds. system-view [Sysname] interface gigabitethernet 1/0/1 [Sysname-GigabitEthernet1/0/1] lldp check-change-interval 30 lldp compliance admin-status cdp Syntax lldp compliance admin-status cdp { disable | txrx } View undo lldp compliance admin-status cdp Layer 2 Ethernet interface view Default level 2: System level Parameters disable: Specifies the disable mode, where CDP-compatible LLDP cannot receive or transmit CDP packets. txrx: Specifies the TxRx mode, where CDP-compatible LLDP can send and receive CDP packets. Description Use lldp compliance admin-status cdp to configure the operating mode of CDP-compatible LLDP on a port. Use undo lldp compliance admin-status cdp to restore the default. By default, CDP-compatible LLDP operates in disable mode. For your device to work with Cisco IP phones, you must enable CDP-compatible LLDP globally and then configure CDP-compatible LLDP to operate in TxRx mode on the specified ports. Related commands: lldp compliance cdp. Examples # Configure CDP-compatible LLDP to operate in TxRx mode on GigabitEthernet 1/0/1. 216