HP StorageWorks MSA 2/8 HP StorageWorks Fabric OS V3.1.x/4.1.x Reference Guide - Page 24

Fabric OS Commands There are six Access Control Lists (ACLs) to restrict SNMP get/set/trap operations to hosts under a host-subnet-area. Host-subnet-area is defined by comparing non-zero IP octets. For example, an ACL of "192.168.64.x" enables access for any hosts that start with the specified octets. The connecting host is enabled as "192.168.64.xx," where xx is any number from 0 to99. All ACL entries also have a flag to set each host-subnet-area to be read-write or read-only. The highest privilege matched out of six entries is given to the access. An ACL check is turned off when all six entries contain "0.0.0.0." Note: When secure mode is enabled, the Access Control List feature is incorporated into the WSNMP (WinSNMP) and Reliable SNMP (RSNMP) security policies. Community strings can be changed on the primary FCS switch only and will propagate changes across the fabric. See "Security Commands" on page 941. Operands Example None. To set the SNMP agent configuration parameters to default values, and verify they were set: switch:admin> agtcfgDefault ***** This command will reset the agent's configuration back to factory default ***** Current SNMP Agent Configuration Customizable MIB-II system variables: sysDescr = Fibre Channel Switch. sysLocation = End User Premise sysContact = sweng sweventTrapLevel = 0 authTraps = 1 (continued on next page) 24 Fabric OS Version 3.1.x/4.1.x Reference Guide