HP StorageWorks MSA 2/8 HP StorageWorks Fabric OS V3.1.x/4.1.x Reference Guide - Page 554

Fabric OS Commands Operands ■ Locked L_Port is displayed as ON when port is locked to L_Port only or blank (--) when L_Port lock mode is disabled (and it behaves as a U_Port). This value is set by the portCfgLport command. ■ Locked G_Port is displayed as ON when port is locked to G_Port only or blank (--) when G_Port lock mode is disabled (and it behaves as a U_Port). This command is set by the portCfgGport command. ■ Disabled E_Port is displayed as ON when port is not allowed to be an E_Port or blank (--) when the port is allowed to function as an E_Port. This command is set by the portCfgEport command. ■ Mcast LoopBack mode (V4.1.x only) is displayed as blank (..) when Mcast LoopBack mode is off, and (ON) when Mcast LoopBack mode is enabled. ■ Persistent Disable is displayed as ON when the port is disabled across reboots or power cycles or (..) when the port is allowed to function normally. This mode is set by the portcfgpersistentdisable command. ■ ISL R_RDY Mode is displayed as ON when the port has been R_RDY mode enabled or blank (--) when the port is allowed to function as an E_Port. This mode is set by the portcfgislmode command. This command has the following operands: slotnumber (V4.1.x only) portnumber Specify the slot number for a StorageWorks Core switch. For all other switches this operand is not required. The slot number must be followed by a slash ( / ) and the port number, so that each port is represented by both slot number (1 through 4, or 7 through 10), and port number (0 through 15). The StorageWorks Core switch has a total of 1-10 slots. Slot number 5 and 6 are control processor cards, and slot 1 through 4, and 7 through 10, are port cards. On each port card, there are 16 ports counted from the bottom, 0 to 15. Specify a port number. Valid values for port number vary depending on the switch type. This operand is optional. 554 Fabric OS Version 3.1.x/4.1.x Reference Guide