HP StorageWorks MSA 2/8 HP StorageWorks Fabric OS V3.1.x/4.1.x Reference Guide - Page 27

agtcfgSet swEventTrapLevel authTraps The event trap level in conjunction with the event's severity level. When an event occurs and if its severity level is at or below the set value, the SNMP trap, swEventTrap, is sent to configured trap recipients. By default, this value is set at 0, implying that no swEventTrap is sent. Possible values are: 0 - none 1 - critical 2 - error 3 - warning 4 - informational 5 - debug When enabled, the authentication trap, authenticationFailure, is transmitted to a configured trap recipient in the event the agent received a protocol message that is not properly authenticated. In the context of SNMPv1 and SNMPv2c, this means that a request contains a community string that is not known to the agent. The default value for this parameter is 0 (disabled). There are six communities and respective trap recipients supported by the agent. The first three communities are for read-write access (rw) and the last three are for read-only access (ro). Note that the factory default value for the trap recipient of each community is "0.0.0.0." The factory default values for the community strings are: ■ Community 1: Secret Code ■ Community 2: OrigEquipMfr ■ Community 3: private ■ Community 4: public ■ Community 5: common ■ Community 6: FibreChannel Note that in order for an SNMP Management Station to receive a trap generated by the agent, the administrator must configure a trap recipient value to correspond to the IP address of the Management Station. In addition, for V4.1.x, the trap recipient must be able to pass the Access Control List (ACL) check. There are six ACLs to restrict SNMP get/set operations to hosts under a host-subnet-area. Host-subnet-area is defined by comparing non-zero IP octets. For example, an ACL of "192.168.64.x" enables access for any hosts that start with the specified octets. The connecting host is enabled as "192.168.64.xx." All Fabric OS Version 3.1.x/4.1.x Reference Guide 27