HP StorageWorks MSA 2/8 HP StorageWorks Fabric OS V3.1.x/4.1.x Reference Guide - Page 383

ipAddrSet Operands ■ Press Ctrl-C to cancel changes ■ Press Ctrl-D to accept changes and end input The final prompt allows you to set the new IP addresses immediately. Enter Y to set new addresses immediately; enter N to delay the changes until the next switch reboot. Entering Y closes the telnet session. A change to these values issues a domain address format RSCN; see FC-FLA for a description of RSCNs. For V3.1.x, none. For V4.1.x, this command has the following operand: option Specify which option you would like to configure. This operand is only available for the StorageWorks Core switch. Valid options are as follows: ■ 0 sets the Ethernet IP address, Ethernet subnetmask, Fibre Channel IP address, and Fibre Channel subnetmask of logical switch 0. ■ 1 sets the Ethernet IP address, Ethernet subnetmask, Fibre Channel IP address, and Fibre Channel subnetmask of logical switch 1. ■ 2 sets the Ethernet IP address, Ethernet subnetmask, gateway IP address, and hostname of CP0. ■ 3 sets the Ethernet IP address, Ethernet subnetmask, gateway IP address, and hostname of CP1. If no operand is specified the command becomes interactive. Example To set the IP address details for a switch (V3.1.x example): switch:admin> ipAddrSet Ethernet IP Address [0.0.0.0]: 192.168.166.148 Ethernet Subnetmask [0.0.0.0]: 255.255.255.0 Fibre Channel IP Address [0.0.0.0]: 192.168.58.135 Fibre Channel Subnetmask [0.0.0.0]: 192.168.166.134 Gateway IP Address [0.0.0.0]: 192.168.166.135 Committing configuration...Done... switch:admin> Fabric OS Version 3.1.x/4.1.x Reference Guide 383