HP StorageWorks MSA 2/8 HP StorageWorks Fabric OS V3.1.x/4.1.x Reference Guide - Page 272

Fabric OS Commands would contain all devices connected to switch 2, ports 12 and 14, and the device with a WWN of "10:00:00:60:69:00:00:8a" (either Node Name or Port Name) whichever port in the fabric it is connected to. The target connected to switch 2, port 12 would be assigned an ALPA value of 0xE2, and the target connected to port switch 2, port 14 would be assigned an ALPA value of 0xE8. Finally, the ALPA assigned to the target identified by the WWN would be assigned a value of 0xEF. Preferred ALPA assignments given to a Domain Port that is not a public N_Port device are ignored, and the fazone is created without error. Note: This command does not change the defined configuration (which you can view using the cfgShow command) until the cfgSave command is issued. For the change to become effective, an appropriate Fabric Assist zone configuration must be enabled using the cfgEnable command. For the change to be preserved across switch reboots, it must be saved to non-volatile memory using the cfgSave command. When security is enabled, this command can only be issued from the Primary FCS switch. See "Security Commands" on page 941. Operands The following operands are required: fazoneName member Specify a name for the Fabric Assist zone. The name must be enclosed in quotation marks. This operand is required. Specify a member or list of members to add to a Fabric Assist zone. The list must be enclosed in quotation marks, and each member must be separated by a semicolon. A member can be specified by one or more of the following methods: ■ For V3.1.x, enter a fabric domain and physical port number pair. ■ For V4.1.x, enter a fabric domain and area number pair. View the area numbers for ports using the switchShow command. ■ WWNs. ■ Fabric Assist zone alias names. ■ Exactly one Fabric Assist host member. This operand is required. 272 Fabric OS Version 3.1.x/4.1.x Reference Guide