HP StorageWorks MSA 2/8 HP StorageWorks Fabric OS V3.1.x/4.1.x Reference Guide - Page 880

Fabric OS Commands Operands Metric: Hops: Flags: Next (Dom, Port): Cost of reaching the destination domain. Maximum number of hops required to reach the destination domain. Indicates if route is dynamic (D) or static (S). A dynamic route is discovered automatically by the FSPF path selection protocol. A static route is assigned using the command uRouteConfig. Domain and port number of the next hop. These are the domain number and the port number of the switch to which Out Port is connected. The information provided by this command should match what is provided by portRouteShow and topologyShow. This command has the following operands: slotnumber (V4.1.x only) portnumber domainnumber Specify the slot number for a StorageWorks Core switch. For all other switches this operand is not required. The slot number must be followed by a slash ( / ) and the port number, so that each port is represented by both slot number (1 through 4, or 7 through 10), and port number (0 through 15). The StorageWorks Core switch has a total of 1-10 slots. Slot number 5 and 6 are control processor cards, and slot 1 through 4, and 7 through 10, are port cards. On each port card, there are 16 ports counted from the bottom, 0 to 15. Specify a port number. Valid values for port number vary depending on the switch type. This operand is optional. Displays routing information for the specified domain. This operand is optional. This operand should only be specified when the port number is specified. If no operand is specified, this command displays routing information for all active ports on the local switch, to all the domains in the fabric. 880 Fabric OS Version 3.1.x/4.1.x Reference Guide