HP StorageWorks MSA 2/8 HP StorageWorks Fabric OS V3.1.x/4.1.x Reference Guide - Page 520

Fabric OS Commands Operands This command has the following operand: slotnumber (V4.1.x only) portnumber interval Specify the slot number for a StorageWorks Core switch. For all other switches this operand is not required. The slot number must be followed by a slash ( / ) and the port number, so that each port is represented by both slot number (1 through 4, or 7 through 10), and port number (0 through 15). The StorageWorks Core switch has a total of 1-10 slots. Slot number 5 and 6 are control processor cards, and slot 1 through 4, and 7 through 10, are port cards. On each port card, there are 16 ports counted from the bottom, 0 to 15. Specify a port number. Valid values for port number vary depending on the switch type. This operand is required. Specify an interval in seconds. This operand is optional. Example To display filter monitor traffic on blade 2 port 5 at an interval of every 6 seconds: switch:admin> perfshowfiltermonitor 2/5, 6 perfShowFilterMonitor 2/5, 6 0 1 2 3 4 5 6 #Frames #CMDs #CMDs #Frames #Frames #CMDs #CMDs 0 0 0 0 0 0 0 26k 187 681 682 682 494 187 26k 177 711 710 710 534 176 26k 184 734 734 734 550 184 26k 182 649 649 649 467 182 26k 188 754 755 755 567 184 26k 183 716 716 717 534 183 26k 167 657 656 655 488 167 26k 179 749 749 749 570 179 26k 164 752 752 752 588 164 26k 190 700 700 700 510 190 26k 181 701 701 701 520 181 26k 200 750 750 751 550 201 26k 180 692 692 691 512 179 26k 179 696 696 696 517 179 26k 187 720 720 720 533 187 26k 200 722 722 722 522 200 26k 204 717 717 717 513 204 520 Fabric OS Version 3.1.x/4.1.x Reference Guide