Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1024

Default Configuration By default, RADIUS attribute 8 is not sent. Command Mode Global Configuration User Guidelines If accounting is enabled and the address is available to the switch, the switch will send the IPv4 address in the Access-Request, Acct-Start/AcctInterim/Acct-Stop messages sent to the RADIUS server. The switch discovers the client IPv4 address via its inclusion in the RADIUS Access-Accept, via DHCPv4 snooping. DHCPv4 snooping must be enabled for the switch to discover a host IPv4 prefix via DHCP. After an Access-Accept has been received by the switch and the switch grants the host access to the network, it may take a few seconds before the DHCP transaction completes. Use the aaa accounting delay-start command to delay the sending of the Acct-Start packet to the accounting server. Accounting packets are not sent for ports placed in the Guest VLAN. Multiple hosts are allowed access on a port configured in 802.1x multi-domain-multi-host mode which is placed in the Guest VLAN. Use the show authentication clients command to display the RADIUS discovered IPv4 address, if any. Command History Introduced in version 6.3.0.1 firmware. Command updated in firmware release 6.5.2. Example console#conf console(config)#radius server attribute 8 include-in-access-req radius server attribute 25 Use the radius server attribute 25 command to globally enable the switch to send the RADIUS Class attribute as supplied by the RADIUS server in accounting messages sent to the accounting server. Security Commands 1024