Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 2332

• vrf-name-The name of the VRF associated with the routing table context used by the command. If no vrf is specified, the global routing table context is used. • ipaddress-Valid IP address of the destination host. • hostname-Hostname of the destination host. (Range: 1-256 characters). The command allows spaces in the host name when specified in double quotes. For example, console(config)#snmpserver host "host name" • initTtl-The initial time-to-live (TTL); the maximum number of router hops between the local and remote system (Range: 1-255). • maxTtl-The largest TTL value that can be used (Range:1-255). • maxFail-Terminate the traceroute after failing to receive a response for this number of consecutive probes (Range: 1-255). • interval-The timeout period. If a response is not received within this period of time, then traceroute considers that probe a failure (printing *) and sends the next probe. If traceroute does receive a response to a probe, then it sends the next probe immediately. (Range: 1-60 seconds). • count-The number of probes to be sent at each TTL level (Range:1- 10). • port-The destination UDP port of the probe. This should be an unused port on the remote destination system (Range: 1-65535). • size-The size, in bytes, of the payload of the Echo Requests sent (Range: 0-39936 bytes). • src-ip-address-The IPv4 source address to use in the ICMP echo request packets. • vlan-id-A valid VLAN interface. • loopback-id-A configured loopback ID Default Configuration The default count is 3 probes. The default interval is 3 seconds. The default size is 0 data bytes. The default port is 33434. The default initTtl is 1 hop. Switch Management Commands 2332