Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1158

console(config)# management access-class mlist management access-list Use the management access-list command in Global Configuration mode to define an access list for management, and enter the access-list configuration mode for editing the access list conditions. Once in access-list configuration mode, access conditions are configured with the deny and permit commands. To remove an access list, use the no form of this command. Syntax management access-list name no management access-list name • name - The access list name. (Range: 1-32 printable characters) Default Configuration This command has no default configuration. Command Mode Global Configuration mode User Guidelines A management access list is only supported on the switched VLAN interfaces. It is not supported on the out-of-band interface. This command enters the access-list configuration mode, where access conditions may be defined with deny and permit commands. If no match criteria are defined the default is to deny the packet (i.e., the packet is dropped). If editing an access-list context, new rules are appended to the end of the access-list. Use the management access-class command to select the active access-list. The active management list cannot be updated or removed. Management access list names can consist of any printable character, including blanks. Enclose the name in quotes to embed blanks in the name. Question marks are disallowed. Security Commands 1158