Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1298

neighbor default-originate (IPv6 Address Family Configuration) To configure BGP to originate a default IPv6 route to a specific neighbor, use the neighbor default-originate command in IPv6 Address Family configuration mode. Syntax neighbor { ip-address | ipv6-address [interface interface-id]} defaultoriginate [route-map map-name] • interface-id-A routing interface identifier (VLAN interface). • ip-address-The neighbor's IPv4 address. • ipv6-address -The neighbor's IPv6 address. If the neighbor's IPv6 address is a link local address, the local interface must also be specified. • map-name-(Optional) A route map may be configured to set attributes on the default route advertised to the neighbor. Default Configuration No default is originated by default. Command Mode IPv6 Address Family Configuration User Guidelines By default, a neighbor-specific default has no MED and the Origin is IGP. Attributes may be set using an optional route map. A neighbor-specific default is only advertised if the Adj-RIB-Out does not include a default learned by other means, either from the default-information originate (BGP Router Configuration) command or a default learned from a peer. This type of default origination is not conditioned on the presence of a default route in the routing table. This form of default origination does not install a default route in the BGP routing table (it will not appear in the show ip bgp command), nor does it install a default route in the Adj-RIB-Out for the update group of peers so configured (it will not appear in the show ip bgp neighbors advertised-routes command). Layer 3 Routing Commands 1298